The comparison of traditional Raymond mill and new Raymond mill

No image available

Sponsored Ads

Price: Check with seller

We all know that Hung high pressure  Raymond mill   (high pressure mill), mainly used for grinding powder...

  • Category: Book Shops
  • Published: 24/09/2014
  • Current Rating: /5 0 Vote

    Description

    We all know that Hung high pressure  Raymond mill   (high pressure mill), mainly used for grinding powder, non-metallic materials use is very convenient, specific non-metallic materials we usually refers to: iron ore, coal stone, blast furnace slag water injection coal, power plant desulfurization agent, boiler, lime, feldspar, quartz, gypsum, barite, limestone, ceramic, slag, such as mohs hardness is not more than 9.3 on the Richter scale, humidity below 6% of inflammable and explosive mines, metallurgy, chemical industry, building materials, and other processing, produced finished product grain size in the range of 80-425 mesh adjustment (the 1000 mesh).


    Traditional Raymond Mill problems:


    1 high failure rate of machinery, large power consumption, big noise, pollution


    2 the fineness of product is low, these devices can only occupy the lowerpowder application market.


    3 the low efficiency of the system, collection system separation effect of the product is not ideal, a large number of fine powder is not effectively collectedand repeat the cycle in the system caused by the power waste


    The design of the bellows duct 4 host mistakes, into larger particles in thegrinding zone material and future and particle grinding broken is often thrown into the bellows aggregation tail in the cochlear box, and continuously extended forward, the wind gradually decrease, easy cause traffic jams, no powder orless powder, effect of yield.


    Advantages of a new type of Raymond mill:


    1, three-dimensional structure, small footprint, complete and strong, expectfinished powder from the block form up an independent production system;


    2, finished powder fineness uniformity, rate of 99% through screening, it is difficult for other milling equipment available;


    3, gear and pulley with sealed gear box, transmission smooth, reliable operation;


    4, the important parts are made of high quality steel, wear resistant parts are high-performance materials, machine wear resistance of high, reliable operation;


    5, the electrical system adopts centralized control, mill shop basically no work can be realized, and the repair is convenient.


    Related Ads

    Leave your comment


    Copyright © 2016 |   All Rights Reserved |   tuffclassified.com |   24x7 support |   Email us: query[at]tuffclassified.com