Category : Distance Learning Courses Posted : 10/02/2015 Price : Check with seller Location : Noida(utter pradesh)
In order to prolong the service life of the components, parts, repair and parts should be used when working conditions of compatible materials, strictly enforce the technical requirements on the drawings; portable crusher parts operation and routine repair, repair carefully, carefully assembled, strict protection of the friction surface, parts of the clean construction, implement repair plan etc..
Portable crusher in the process of operation, various parts subject to wear under the force of friction, the most easy to wear consumption parts machine parts, movable fixed machine parts, flat machine parts, machine parts, flat thrust plate etc.. But sometimes because of the long-term operation of the accident causing premature wear or damage and wear, lubrication system, lubrication system, shaft eccentric shaft, connecting rod, eccentric bearings, bearing parts, lubrication system components also need to repair, to ensure its effectiveness.
Portable crusher parts operation and routine repair, then the impact of mobile crusher parts premature wear and damage factors:
Structure and working quality of mobile crusher parts;The physical and mechanical properties of broken ore;Ore crushing ratio;Portable crusher parts material;The quality of the installation of mobile crushing machine;The use and maintenance of mobile crushing quality and maintenance is not timely.
The following describes several main parts replacement and repair. Wear the mobile crusher fixed jaw and lubrication system of the machine parts, more than in the lower, when the tooth wear out 3/5, namely the need to replace the new machine parts.
On the back of the machine parts should be rough machining, assembly and the body and the collar body contact must be good, no feet hanging phenomenon, when necessary research or grinding wheel flat. Portable crusher parts operation and routine repair, assembly lubrication system of tooth plate, the first to pull the tooth, each supporting plate is welded on the upper jaw, the upper wedge pressing, the gap between the wedge and the jaw decent should be maintained at 10-20mm.
The fixed tooth plate assembly, check the frame of the lower part of the front wall block wear iron, machine parts and the end of the iron block good contact; both sides of the machine parts wear out 2/5, also need to replace the new.
portable crusher: http://www.countryforourcountry.org/application/portable-crusher.html